User guide

STUDIO SC USER GUIDE
To allocate a scene (preset) to a register:
1. Set up the required scene on preset A or B
2. Press and hold the Grab button
3. Press the button under the required register
4. The scene is now stored
5. Release the Grab key
To clear a Register:
1. Make sure that all faders on presets A or B are at zero
2. Press and hold Grab button
3. Press the button under the Register to be cleared. The Register is now empty.
To copy a scene from a register to another:
1. Raise the Register of the scene to be copied
2. Press and hold down Grab key
3. Press the button under the Register to receive the scene
To add a channel to an existing scene:
1. Raise the Register containing the scene
2. Set the new channel to the required level on the A preset
3. Press and hold the Grab key
4. Press and release the Registers button under the relevant fader
5. Release the Grab key
6. Fade out the channel on the A preset. The new scene is now recorded.
Changing the level of a channel in a recorded Register:
1. Raise the Register containing the scene
2. Press and hold the Link key
3. Move fader, on A preset, of the channel to be adjusted to its new level
4. Release the Link key
5. Press and hold down the Grab key
6. Press and release the Register's button under the register
7. Release the Grab key
8. Press and hold the Link key
9. Press and release the channel key
10. Release the Link key
11.Put the fader of the changed channel to zero
12.The new channel level is now recorded in the register
SGM Light Technology 12/12/2000 Ver. 2.04
13