User guide

PILOT 2000 USER GUIDE

To select a Chase:

1. Press Chase key

2.Press a button of the MFK according to the chase to be created or modified

Up to 4 Chases at the same time can be run in one memory.

To select a Psycho:

1. Press Psycho key

2.Press a button of the MFK according to the psycho to be created or modified

Up to 4 Psychos at the same time can be run in one memory.

To select a Preset:

1. Press Preset key

2.Press a button of the MFK according to the preset to be created or modified

Up to 4 Presets at the same time can be run in one memory.

To allocate a Memory Obj to a Memory:

1. Select a Memory

2. Select the Memory Obj to be assigned to a Memory

3. Press and hold down the Store button

4. Press a button of the MFK according to the Memory to be stored

5. Release Store button. The memory is now stored.

To copy the contents of a Memory to another:

1. Select the source Memory

2. Press and hold down the Store button

3. At the same time press a button of the MFK according to the target Memory to be

copied

4. Release Store button. The target memory is now copied.

To select a Unit:

1. Press Unit key

2.Press a button of the MFK according to the unit to be used manually or plotted in a

program.

Group of units:

There are 6 groups of units available which can be stored and recalled by using the 6 light

gray buttons located below the faders of the scan control section.

SGM Light Technology 30/06/2000 Ver. 2.03