User guide

PILOT 2000 USER GUIDE
Grand Master
The Pilot 2000 has a general output level control, used to adjust the overall level of all the
"dimmer" channels, whether they are of the traditional type or of intelligent fixtures.
The value is shown as a percentage, with a range of 0 - 100%.
Scan Control Section
This section includes the universal controls that are used to control the fixtures and the
entire Pilot itself.
The functions vary according to the operating mode selected on the Programming
Keyboard. Moving head unit/scanner controls are completed by a joystick (which operates
on absolute coordinates) and 4 cursor buttons (which operates on relative coordinates).
The combination of these two systems ensures extremely precise control when positioning
fixtures.
Multifunction Keyboard Section
The key function and the white printing identify this section. It consists of the 20 buttons
located at the bottom of the desk. According to the function selected, this keyboard can be
used to recall Memories, Programs, Chases, Psychos, Presets, Units or Steps
Following the Multifunction Keyboard will be called MFK.
To change Page:
1.Push the Page button.
Only 2 pages are available: red LED not lit means that the selection of buttons 1-20 is
enabled (page 1); when the red LED on the button is lit, it means that the MFK is set to
enable the selection of buttons 21-40 (page 2).
To select a Memory:
1. Press Memory key
2.Press a button of the MFK according to the memory to be run.
One memory per time can be run.
To select a Program:
1. Press Program key
2.Press a button of the MFK according to the program to be created or modified
Up to 4 Programs at the same time can be run in one memory.
8
SGM Light Technology 30/06/2000 Ver. 2.03