Manualshelf

User guide

ManualsBrandsSGM ManualsFlood LightPilot 2000
20212223242526272829
PILOT 2000 USER GUIDE
To set the Hard/Soft Cross:
1. Scroll with the up/down arrows until “Hard/Soft Cross” appears on the display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set here each channel as Soft or Hard. Soft allows to
change the status, of a single parameter, to time. Hard mode, allow the snap
changing, of the status of a single parameter, at the fastest speed available when
running into a sequence
4. Press the left-hand Scroll button to escape the menu.
To set the Reset/Lamp value:
1. Scroll with the up/down arrows until “Reset/Lamp value” appears on the display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set the channel for the remote reset and remote lamp
ON/OFF and the On/Off values which enable the parameters to act.
4. Press the left-hand Scroll button to escape the menu.
To set the Dip-switch configuration:
1. Scroll with the up/down arrows until “Dip-switch configuration” appears on the
display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set here the quantity of dip-switches the fixture uses to
assign the start address. SGM’s fixtures use 9 switch dip-switches.
4. Press the left-hand Scroll button to escape the menu.
To set the Beam find value:
1. Scroll with the up/down arrows until “Beam Find Value” appears on the display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set here the open position to those channels
parameters which allows the operator to see the fixture’s beam when setting the
Working Area (iris open; dimmer open; strobe open; white open to gobo and color)
4. Press the left-hand Scroll button to escape the menu.
To set the Control Type for each parameter:
1. Scroll with the up/down arrows until “Control Type” appears on the display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set here the control type for the fixture’s channels. The
control type can be Linear (Lin) or Tabled (Tab).
4. Lin channels use all the DMX range of values to control a fixture’s function while
Tab channels use only the DMX values, which select a specific Gobo or Color.
5. Press the left-hand Scroll button to escape the menu.
22
SGM Light Technology 30/06/2000 Ver. 2.03