User guide

PILOT 2000 USER GUIDE
To set the Length of a Program or Chase:
The desk automatically increases the steps of a Program or Chase. By the way, if the
length need to be changed, proceed as follows:
1. Select a Memory
2. Select the desired Chase or Program
3. Press Edit Key
4. The display will shows the default length or the value previously set
5. By using the fader below the Length field or the UP/DOWN arrows, it is now possible
to set the desired value.
6. Press Edit Key
7. Press Enter Key
8. The Length is now stored
To change step’s time of a Program or Chase:
The default Step’s time is set on 2 sec. and 50% of cross time, but it is possible to change
it up to 99.9 sec and 100% of cross time.
1.Press Edit Key
2.Press right arrow of scroll buttons
3.Select Step’s Time from the Edit Menu
4.Press right arrow
5.It is now possible to change the Time and the Cross for each step
6.Press Edit button once completed the modification
7.Press Enter
Times of a Memory Obj :
1. Press Times button
2. The display will show the menu in which you can increase or decrease the speed of a
Memory Obj.
Times of a Chase or Program:
When a Chase or a Program is selected, it’s possible to modify the following fields:
1. TRIG: is the clock, which let the Chase or Program to flow. It could be Internal
(INTRN) for a timed changing scenes or Music (MUSIC) for a sound to light changing
scenes.
2. RUN: to change the flowing direction of the Chase or Program. It could be Normal (as
programmed) or Backward (opposite direction than programmed).
3. SPEED%: is the running speed of a Chase or Program which can be set from 25% to
400% of default speed
16
SGM Light Technology 30/06/2000 Ver. 2.03