User guide

PILOT 2000 USER GUIDE

Patching Units

WARNING!

To avoid patching conflict, don’t let the Unit Channels to overlap the Dimming channels

or the Extra Channels

1. Press the Setup button.

2. Scroll with the up/down arrows until “Unit Patch” appears on the display.

3. Press the right-hand Scroll button.

4. Press a key of the Multifunction Keyboard .

5. Press the right-hand button of the cursor to set the field to be changed.

6. With the buttons Up/Down select the fixture to be patched

7. With the Left/Right buttons select the From field (start address) and set the value

required

8. Check the configuration of the dip-switches shown on the display and set it on the

fixture.

9. Press the Setup button to store the configuration and leave Unit Patch Menu.

Patching Extra channels

WARNING!

To avoid patching conflict, don’t let the Extra Channels to overlap the Dimming channels

or the Unit Channels

1. Press the Setup button.

2. Scroll with the up/down arrows until “Extra Patch” appears on the display.

3. Press the right-hand Scroll button.

4. By using the fader below the Extra field or with the buttons Up/Down, select the Extra

channel to be patched

5. With the Left/Right buttons select the DMX-CH field and set the required DMX channel

to be linked to the Extra channel

6. In the Label field, it possible to assign a name to the Extra channel. Press the light

gray button below the Label fader to access the field. Then the up/down arrows allow

the selection of the letters while left/right arrows allow the cursor to shift to the next

letter to be modified.

7. Once the name has been inserted push the Label button to exit the field

8. To change the Key mode of the Extra channel, press the light gray button below the

Key field. 2 modes are available: OR and AND. When the OR mode is set, it's

possible to control the Extra Channel either by using the universal fader and using the

button as a flash control (flash always has a value of 255). When AND mode is

chosen, the Extra channel is only enabled for as long as the button is pressed and its

output level regulated by the fader.

9. To change the equalization curve, press the light gray button located in

correspondence to the Equal field. Two curves are available: ON/OFF and LIN.

10.Press the Setup button to store the settings and leave Extra Patch Menu.

SGM Light Technology 30/06/2000 Ver. 2.03