Specifications

GB SGM Elettronica - Light Technology

Palco 3 - Palco 5 - 43 - User's manual 1.01

Installing the new front lens panel

1 Carefully position the new set of lenses, paying particular attention to the alignment of the LEDs in relation to the

lenses.

ATTENTION !!

before positioning the new set of lenses, carefully clean the LEDs with a soft dry cloth.

CAREFULLY AVOID TOUCHING THE LEDs – should this occur, clean them with a dry cloth, under no

circumstances using solvents, products for removing grease, or abrasive objects.

Once the new set of lenses is positioned, fix it to the matrix with the appropriate screws, without tightening them

individually, but following an orderly sequence, progressively tightening them in one after another.

2 Replace the front glass, after having cleaned it with a soft dry cloth.

3 Close the 2 (top and bottom) shells of the head, ensuring that the front glass is evenly closed between them.

4 Fix the two shells with the appropriate rear screws.