Specifications

GB SGM Elettronica - Light Technology
Palco 3 - Palco 5 - 39 - User's manual 1.01
Step 5 - END TIME
END TIME is used to configure: the hour, minutes and seconds in which an event containing a previously prepared
program will end.
1. Use the UP key to pass to the “END_h=0” menu
2. Press “Enter” and “END_h=” will begin to flash
3. Use the UP/DOWN keys to choose the hour at which the program has to end
(from 0 to 23)
4. Press “Enter” to exit the “END_h” menu and confirm
1. Use the UP key to pass to the “END_m=0” menu
2. Press “Enter” and “END_m=” will begin to flash
3. Use the UP/DOWN keys to choose the minutes at which the program has to
end (from 0 to 59)
4. Press “Enter” to exit the “END_m” menu and confirm
1. Use the UP key to pass to the “END_s=0” menu
2. Press “Enter” and “END_s=” will begin to flash
3. Use the UP/DOWN keys to choose the seconds at which the program has to end (from
0 to 59)
4. Press “Enter” to exit the “END_s” menu and confirm
Step 6 – ENABLING AN EVENT
1. Use the UP key to pass to the “ENABLE=OFF” menu
2. Press “Enter” and “ENABLE=” will begin to flash
3. Use the UP/DOWN keys to choose ON to enable the event, or OFF if it is to be
disabled.
4. Press “Enter” to exit the “ENABLE” menu and confirm
Repeat the above steps to program other events on the Palco.
Once programming is finished, keep “Enter” pressed down for approximately 6 sec. In order to exit the SCHEDULER
menu.
Step 7 – ENABLING THE SCHEDULER
To start the scheduler and all its “Actions”, it’s necessary to enter the SCHEDL=ON menu
1. Use the UP/DOWN keys to find the “SCHEDL=ON” menu
2. Press “Enter” and SCHEDL= will immediately begin to flash
3. Use the UP/DOWN keys to choose ON or OFF, according to requirements
4. Press “Enter” to exit the SCHEDL=ON menu and confirm
END_h=23
END_m=30
END_s=30
ENABLE=ON
PRGRUN=1