Specifications

SGM Elettronica - Light Technology GB
User's manual 1.01 - 36 - Palco 3 - Palco 5
Step 10 - FADE TIME
The FTIME menu gives access to the adjustment of the scene fade time. The time can be configured in hours, minutes
and seconds
1. Use the UP key to pass to the “FTIME_h=0” menu
2. Press “Enter” and “FTIME_h=” will begin to flash
3. Use the UP/DOWN keys to choose the number of hours of the current scene’s
fade time.
4. Press “Enter” to exit the “FTIME_h” menu and confirm
1. Use the UP key to pass to the “FTIME_m=0” menu
2. Press “Enter” and “FTIME_m=” will begin to flash
3. Use the UP/DOWN keys to choose the number of minutes of the current scene’s fade
time.
4. Press “Enter” to exit the “FTIME_m” menu and confirm
1. Use the UP key to pass to the “FTIME_s=0” menu
2. Press “Enter” and “FTIME_s=” will begin to flash
3. Use the UP/DOWN keys to choose the number of seconds of the current scene’s fade
time.
4. Press “Enter” to exit the “FTIME_s” menu and confirm
ATTENTION !!
The program does not display the scene if its scene time is ZERO.
If the scene time is less than the fade time, the scene will not reach its value, but will be cut
along the fade time when the scene time finishes.
Step 11 – ENABLING SCENES
Enabling a scene decides if the scene will be run or not when the program is run. The SCNRUN menu is also useful when
it is necessary to temporarily eliminate the playback of some scenes in a program without cancelling them.
1. Use the UP key to pass to the “SCNRUN=OFF” menu
2. Press “Enter” and “SCNRUN=” will begin to flash
3. Use the UP/DOWN keys to choose ON to enable the scene, or OFF if it has not
to be run.
4. Press “Enter” to exit the SCNRN menu and confirm
Repeat the above steps to program other scenes on the Palco.
Once programming is finished, keep “Enter” pressed down for approximately 6 sec. In order to exit the PROGRAMMER
menu.
FTIME_h=0
FTIME_m=3
FTIME_s=0
SCNRUN=ON