Specifications

GB SGM Elettronica - Light Technology
Palco 3 - Palco 5 - 31 - User's manual 1.01
Programmer
The Programmer menu allows to carry out Palco’s on-board programming for any stand-alone operation without external
DMX control. The “Programmer” menu also allows to program a maximum of 29 SLAVE fixtures connected to the
MASTER fixture with the on-board programming.
The fundamental stages of the Palco’s programming are as follows:
1. Entering the “PROGRAMMER” menu
2. Choosing the Program number
3. Choosing the scene number
4. Choosing the number of Slaves (if any) involved in the scene
5. Setting scene parameters
6. Choosing the scene times
7. Choosing the fade times
8. Optional scene disabling and enabling
The “Stand-Alone Programming” chapter describes all the operations necessary for programming in detail.
Scheduler
The Scheduler menu gives access to the programming of “events” able to run the playback of programs previously
prepared on-board the Palco, with the necessary times and modes. There are 48 events and each one can control the
start and stop time of a program day by day on a weekly basis.
The fundamental stages of programming the Scheduler are as follows:
1. Entering the Scheduler menu
2. Choosing the event number
3. Choosing the program number
4. Choosing the day,
5. hours and minutes of the event’s start
6. hours and minutes of the event’s end
7. Optional event disabling and enabling
The “Stand-Alone Programming” chapter describes all the operations necessary for Scheduler programming in detail.