Specifications

GB SGM Elettronica - Light Technology
Palco 3 - Palco 5 - 29 - User's manual 1.01
Test functions
Using the test menu, it’s possible to test the correct operation of the channels that control the Palco.
1. Use the UP/DOWN keys to find the “TEST” menu
2. Press “Enter” and hold it down for a few seconds to confirm the choice. The text on
the display will begin to flash.
3.
Use the UP/DOWN keys to select the physical channel to be tested
(ALL - SHUTT - DIMMR - RED - GREEN - BLUE - CTC)
4. Press “Enter” and the selected text will begin to flash, running a test routine on the
chosen channel.
5. Press “Enter” again to exit the routine being run and choose another channels to be
tested
6. Keep “Enter” pressed down for a few seconds if you wish to exit the TEST menu
Head temperature
The TEMPERATUR menu is used to view the current temperature of the Palco’s head. In some critical heat conditions,
it’s very important to know the temperature of the Palco, as a self-protection system of the LEDs cuts overall power
when Palco is required to work at excessively high temperatures.
1. Use the UP/DOWN keys to find the “TEMPERATUR” menu
2. Press “Enter” and the current temperature will be immediately displayed
3. Using the UP/DOWN keys, it’s possible to display the temperature in degrees
Centigrade or Fahrenheit
4. Press “Enter” to exit the TEMPERATUR menu
Configuring a Master
When a system with several interconnected fixtures has to be used in Stand-alone mode, there has to be one MASTER
fixture, able to control the other fixtures, via appropriate on-board programming.
1. Use the UP/DOWN keys to find the “MASTER” menu
2. Press “Enter” and the displayed text will immediately begin to flash
3. Use the UP/DOWN keys to choose ON or OFF status
4. Press “Enter” to exit the MASTER menu
TEST=BLUE
TEMPERATUR
HEAD=21°C
MASTER=ON