Specifications

SGM Elettronica - Light Technology GB
User's manual 1.01 - 28 - Palco 3 - Palco 5
Time
It’s just as important to set Palco’s on-board clock if it has to be used later in Stand-alone mode.
1. Use the UP/DOWN keys to find the “C” (Clock) menu
2. Press “Enter” to confirm the choice. The first two numbers (relative to the hours) will
begin to flash on the display.
3. Use the UP/DOWN keys to select the current time (the hour – from 00 to 23).
4. Press “Enter” to move the setting from the hours to the minutes
5. Use the UP/DOWN keys to select the current time (the minutes – from 00 to 59).
6. Press “Enter” to move the setting from the minutes to the seconds
7. Use the UP/DOWN keys to select the current time (the seconds – from 00 to 59).
8. hold “Enter” pressed down for approx. 6sec. to confirm the new time
Setting default parameters
This enables to set the default parameters
5. Use the UP/DOWN keys to find the “FACT” menu
6. Press “Enter” to confirm the choice. The text on the display will begin to flash.
7.
Use the UP/DOWN keys to select ”FACT=SET” and press “Enter”
8. Press “Enter” to set the default parameters shown in the table. “FACT=OFF”
appears on the display
Menu item Default parameter
ADDR 001
BRIGHT 40%
DMXDLY UNL
Resetting default parameters
This enables to reset the parameter values set immediately before the FACT=SET operation. In other words, if the
default parameters have been set by mistake, this operation allows to revert to the values set previously.
1. Use the UP/DOWN keys to find the “Prev” menu
2. Press “Enter” and hold it down for a few seconds to confirm the choice. The text on
the display will begin to flash.
3. Use the UP/DOWN keys to select ”PREV=SET”
4. Pressing “Enter” in this mode resets the values, cancelling the FACTORY DEFAULT
operation. In the meanwhile, PREV stops flashing and the message that appears is
PREV=OFF
FACT=SET
FACT=OFF
PREV=SET
PREV=OFF
C 12:06:20