Specifications

GB SGM Elettronica - Light Technology
Palco 3 - Palco 5 - 27 - User's manual 1.01
Display brightness
Operators can select one of the brightnesses available for the Palco (standard or very low). This option was included for
theatre and television use, where excessive brightness can be disturbing. To adjust display brightness, proceed as
follows:
1. Use the UP/DOWN keys to find the “Bright” menu
2. Press “Enter” to confirm the choice. The text on the display will begin to flash.
3.
Use the UP/DOWN keys to select the required option from those available.
4. Press “Enter” to confirm the changes.
Invert display
When the fixture is suspended “upside down” from a structure, the operator can turn the text on the display through
180°, thus enabling the menus available to be easily read.
To change the reading angle, proceed as follows:
1. Use the UP/DOWN keys to find the “Dspl Flip” menu
2. Press “Enter” to confirm the choice. The text on the display will begin to flash.
3. Use the UP/DOWN keys to select the required option.
4. Press “Enter” to confirm the changes.
DMX delay
It’s possible to decide for how many seconds the fixture must hold the last operating status if there is no DMX signal.
“Delay” time can be set between 0 and 998 seconds. If set at UNL, the fixture will hold its standby status for an
unlimited time. This function is indispensable in the event of the DMX signal being accidentally interrupted. To set the
required time, proceed as follows:
1. Use the UP/DOWN keys to find the “DMXDLY” menu
2. Press “Enter” to confirm the choice. The text on the display will begin to flash.
3. Use the UP/DOWN keys to select the required length of time. If UNL (unlimited) is set,
the last valid operating status is held no matter for how long the DMX signal is
missing.
4. Press “Enter” to confirm the changes.
Days of the week
It is of fundamental importance to set the day of the week on the Palco if it has to be used later in Stand-alone mode.
1. Use the UP/DOWN keys to find the “DAY” menu
2. Press “Enter” to confirm the choice. The text on the display will begin to flash.
3. Use the UP/DOWN keys to select the current day of the week.
4. Press “Enter” to confirm.
BRIGHT=40%
DSPL FLIP
DMXDLY=20
DAY=TUE