Specifications

GB SGM Elettronica - Light Technology
Palco 3 - Palco 5 - 25 - User's manual 1.01
Addressing
This menu gives access to fixture addressing functions. See Installation – Addressing Chapter)
1. Use the UP/DOWN keys to find the “Addr” menu
2. Press “Enter” to confirm the choice. The text on the display will begin to flash.
3.
Use the UP/DOWN keys to select the required start channel.
4. Press “Enter” to confirm the choice.
Colour Balance
This menu gives access to the setting of Palco’s white balance. If it’s necessary to work with a fixed colour temperature,
this menu must be used.
1. Use the UP/DOWN keys to find the “COLBALANCE” menu
2. Press “Enter” for approximately six seconds.
3. “Rblnc=100%” will appear on the display and the Palco will switch on at maximum
RGB values
4. Press “Enter” again and “Rblnc=” will begin to flash
5. Use the UP/DOWN keys to adjust the new maximum value required for the Red
channel.
6. Press “Enter” to confirm the choice.
1. Use the UP key to select “Gblnc=100%”
2. Press “Enter” again and “Gblnc=” will begin to flash
3. Use the UP/DOWN keys to adjust the new maximum value required for the Green
channel.
4. Press “Enter” to confirm the choice.
1. Use the UP key to select “Bblnc=100%”
2. Press “Enter” again and “Bblnc=” will begin to flash
3. Use the UP/DOWN keys to adjust the new maximum value required for the Blue
channel.
4. Press “Enter” to confirm the choice.
5. Press “Enter” for approximately six seconds to exit the COLORBALANCE menu.
Balance
The “Balance” menu allows to enable or disable the white balance, previously set using the COLORBALANCE menu
1. Use the UP/DOWN keys to find the “BALANC=OFF” menu
2. Press “Enter” and the displayed text will immediately begin to flash
3. Use the UP/DOWN keys to choose ON or OFF status
4. Press “Enter” to exit the BALANC menu
Addr=xxx
COLBALANCE
Rblnc=60%
Gblnc=100%
Bblnc=98%
BALANC=ON