Specifications

SGM Elettronica - Light Technology GB
User's manual 1.01 - 18 - Palco 3 - Palco 5
To change the DMX address, proceed as follows:
 Press the UP key. The message Addr=1 will appear
 Press Enter and “Addr=” will begin to flash
 Use the UP and Down arrow keys to choose the required address
channel
 Press Enter again to confirm
Palco requires 8 DMX channels for the control of all its functions.
With a DMX 512 control universe, up to 64 can therefore be controlled simultaneously and separately
ATTENTION: do not use more than 25 fixtures on any one DMX line! Should it be necessary to
connect a larger number of fixtures, the appropriate Buffers or Splitter must be used for each 25
fixtures, to ensure that the signal quality remains unchanged.
Check the following table to see the exact DMX address for each fixture connected on the same DMX line.