User`s guide

Hardware Replacement Procedures
007-5483-001 67
Replacing the Power Supplies
Note: Power supplies can be hot-swapped while the system is in operation in a rack.
Have the replacement power supply ready, so that it can be installed quickly without
disrupting the airflow through the chassis.
1. If necessary, remove the front bezel from the system in accordance with the
instructions on
page 64.
2. Move the power supply latch to release the power supply (refer to Figure 3-8).
3. Grasp the handle and pull the supply out of the chassis.
4. Slide the replacement supply in the chassis, and press it in until the latch can lock it
into place.
5. Verify the status LED on the replacement power supply is green.
Figure 3-8 Power Supply Removal