User`s guide

Paper Specifications B-13
OG L
Adhesive Label Configuration
The illustration on the left shows label stock with space between the individual labels.
This can cause paper jams and/or labels to peel off during the printing process. The
illustration on the center shows label stock without spaces, but each labels has rounded
corner. This can also cause paper jams and /or labels to peel off.
The illustration on the right shows the recommended label stock without spaces
between the individual labels, and each labels has no rounded corner. Refer to
“Adhesive Label Specifications” on page B-14 when purchasing label stock.
Figure B-7. Adhesive Label Configuration
Storing Labels
■ Store the labels in a clean, dry location where the temperature can be maintained
at 18° to 26°C (64° to 79°F) and the relative humidity does not exceed 55%.
■ Allow the labels to adjust to the printer room environment before opening the
label carton or package. Move the labels into the printer room at least 24 hours
prior to opening the carton or package.
■ Leave the labels in the original package until printing is ready to begin. Replace
the unused labels in the original package and then reseal the package with tape or
store the unused labels in a plastic bag.
■ Do not leave labels in the hopper of an inactive printer overnight or for long
periods of time.
■ Use the labels on a first-in, first-out basis.
Not RecommendedNot Recommended
Label
Sheet
Recommended
Backing
Sheet
Backing
Sheet
Label
SheetBacking
Sheet
Label
0 0