User`s guide

B-10 Paper Specifications
OG L
Prepunched Paper
Prepunched paper should be flat and without deformation. Do not use paper with
ragged or damaged hole edges. Any paper pieces resulting from the punching operation
and paper dust should be removed before using.
Use prepunched paper with holes that conform to the following specifications:
■ Maximum of four holes.
■ Maximum hole diameter of 8.0 mm (0.315 in.).
■ Holes must not be located in or protrude into the shaded area shown below.
(a) Face down stacking in simplex print and Face up stacking in duplex print
Figure B-5. Prepunched Paper (1)
Feed Direction
Unit : mm
Front Side Edge
Holes may be available
in this area when face
up stacking.
This area is no conce
rn
with A4, B5, Letter,
Legal and Custom siz
e
of paper.
0 0