User`s guide

Troubleshooting 5-7
OG L
Printer Notice
Followings are consideration matter when using this printer.
■ Printing Speed Down
Printing speed may be reduced when following conditions.
❒ Printing of complex job.
❒ Printing a job with job offset.
❒ Printing a jog with switching the input trays.
❒ Printing a job with high moisture paper under the condition of low voltage and
low room temperature.
❒ Continuous printing with high toner coverage (over 25% coverage).
❒ After clearing the engine error (Paper Jam, etc.).
❒ Printing a PostScript job after many PostScript job using Global VM is
printed.
■ IPP Printing
IPP printing cannot be used if the print job is sent from WindowsXP via the
Multi-protocol NIC option port.
■ Offset Stacking
Offset stacking is not worked when the paper length is longer than 431.8mm (17
inches).
■ “Prior Pick Mode” of the HCF Tray Control
There are some limitations when you use the printer in the “Prior Pick Mode”.
❒ If you use the auto cascading of the Input Tray, printer can only cascade the
tray to vertical direction. Therefore, you can set the same paper for cascading
to following tray combinations only.
- Tray 1 and Tray 2
- HCF1 Lower and HCF1 Upper
- HCF2 Lower and HCF2 Upper
❒ In this mode, a few paper might remain on the paper path in the HCF when the
printer is stopped by paper empty.
Normally, these papers are used for next printing, but if following condition is
occurred, these papers in the HCF need to be removed.
- Job is not completed by canceling a job.
- HCF Front Cover or HCF Top Cover is opened.
- The Down Switch of the Tray which supplied remaining papers is pressed
for open the Tray. (The Tray which supplied remaining papers cannot be
opened unless the Down Switch is pressed.)
0 1