User`s guide

Safety Summary -4
SAFETY SUMMARY
OG L
■ “Do not use solvent on the printer. Using solvent may dissolve the plastic and
paint of the printer.” on page 4-51
■ “Do not use cleaning solutions to clean inside and around the printer. Use only a
water-moistened cloth.” on page 4-51
■ “For cleaning up toner or developer spillage, use a specially-designed toner-safe
vacuum cleaner. If you use a regular vacuum cleaner, the drawn toner/developer
powder may scatter in the air. If you inhale or your eyes come into contact with
such powder, you may feel sick or injure your eyes. Further, the drawn toner/
developer powder may render the vacuum cleaner defective when it enters the
vacuum cleaner’s motor section.” on page 4-51
■ “The Paper Height Sensor in the Tray is sensitive. Carefully cleaning a Tray to
avoid a damage to the Paper Height Sensor.” on page 4-52
■ “If the message “Open the Fuser cover, and check that there is no paper” is
displayed with E31x Call for Service error, open the Fuser cover and check the
Fuser unit refer to Chapter 4.” on page 5-24
■ “Do not use paper that contains CaCO3 as it can drastically reduce fuser life.” on
page B-4
■ “Adhesive that comes in contact with the printer may contaminate the
photoconductor and the internal printer mechanism. To test label stock for
adhesive exposure, press a sheet of plain paper against a sheet of label stock. The
plain paper should not adhere to the label stock at all.” on page B-12
0 2