User`s guide

Safety Summary -3
SAFETY SUMMARY
OG L
■ “Once the printer is powered off, wait at least 5 seconds to next power on.” on
page 1-6
■ “If the message “Open the Fuser cover, and check that there is no paper” is
displayed on the OCP, open the Fuser cover and check the Fuser unit refer to
Chapter 4.” on page 1-9
■ “If the printer does not power on, power off the printer, wait at least 30 seconds,
then power on the printer again.” on page 1-6
■ “You must set the correct paper weight value. The incorrect paper weight value
may cause paper jam.” on page 3-20
■ “Depending on amount of paper, the Basket is very heavy. Take care not to hurt
your back when lifting a heavy Basket.” on page 3-30
■ “Toner is not harmful to the human body, but if some toner has come in contact
with your skin or clothes, you should wash it immediately with cold water.” on
page 4-3
■ “The toner is not harmful to the human body. However, take care not to inhale or
swallow it because you may feel sick.” on page 4-6
■ “If the toner goes into your eyes, immediately rinse with running water. If
affected eyes are not rinsed, it may become injured. If the skin or clothing is
contacted, wash with soap and water” on page 4-6
■ “Hold the developer bottle when you turn the cap so that the bottle is not turned
together with the cap.” on page 4-10
■ “Hold the developer bottle when you turn the cap so that the bottle is not turned
together with the cap.” on page 4-13
■ “Incorrect setting of the Developer Bottle cause damage to the Developer Unit.
Make sure the setting of the Developer Bottle before go to next step.” on page 4-
13
■ “If the developer is spilled out on the floor, the floor becomes very slippy. This
may result in a fall and/or injury. Clean up the spilled developer with a toner-safe
vacuum cleaner.” on page 4-15
■ “If the developer goes into your eyes, immediately rinse with running water. If
affected eyes are not rinsed, it may become injured. If the skin or clothing is
contacted, wash with soap and water” on page 4-15
■ “Surface of the Photoconductor Drum (OPC Sheet) is very sensitive. Carefully
remove a paper to avoid scratch the surface of the Photoconductor Drum.” on
page 4-32
■ “The paper in the Fuser Unit must be removed by step 8 to step 14 when the Fuser
Jam is happened. If the paper remains in the Fuser Unit, paper is scorched, or it
causes another paper jam, or it causes some mechanical damage.” on page 4-33
■ “Incompletion of closing the Fuser Unit Cover and the Paper Guide cause damage
to the Fuser Unit. Make sure the Fuser Unit Cover and the Paper Guide are
completely closed.” on page 4-36
■ “Power off the printer prior to cleaning.” on page 4-51
0 2