User`s guide

Care and Maintenance 4-15
OG L
8. Turn the bottle cap back about 160 degrees in the direction of the arrow until it
stops and remove the developer bottle.
Figure 4-26. Replacing the Developer Mix (16)
9. Place the duct cap back on the developer duct.
10. If the developer spills out, wipe it away thoroughly.
NOTE:
Do not dispose the empty developer bottle after replacing. keep it until
next developer replacement because it will be used at that point.
CAUTION!
If the developer is spilled out on the floor, the floor becomes very slippy.
This may result in a fall and/or injury. Clean up the spilled developer with
a toner-safe vacuum cleaner.
If the developer goes into your eyes, immediately rinse with running water.
If affected eyes are not rinsed, it may become injured. If the skin or
clothing is contacted, wash with soap and water
0 1