User guide

English

English-3

Quick Start

Figure A

Figure B

To attach the F190 Display to your system, follow these instructions:

1. Turn off the power to your computer.

2. For Workstations with DVI digital output: Connect the DVI signal cable (included) to the connector of the graphics card

in your system (Figure A). Tighten all screws.

For Workstations with Analog output: Connect the 15-pin mini D-SUB signal cable (supplied with the Workstation) to

the connector of the graphics card in your system (Figure B). Tighten all screws.

3. Connect either or the 15-pin mini D-SUB of the video signal cable and DVI signal cable to the appropriate connector

on the back of the display (Figure C).

4. Connect one end of the power cord to the F190 Display and the other end to the power outlet.

Collect cables and keep them at backside of the stand and cover the cables by the optional Cable management

Cover (Figure C).

Please check Tilt, Rise and Lower monitor screen when you manage cables.

5. The vacation switch on the left side of the display must be turned on (Figure D). Turn on the display with the front

power button and the computer.

Note: The vacation switch is a true on/off switch. If this switch is on the OFF position, the display cannot be

turned on using the front button. DO NOT switch on/off repeatedly.

6. Analog input only: No-Touch Auto Adjust automatically adjusts the display to optimal settings upon initial setup for

most timings. For further adjustments, use the following OSD controls:

•Auto Adjust Contrast

•Auto Adjust

Refer to the Controls section of this User’s Manual for a full description of these OSD controls.

Note: If you have any problems, please refer to the Troubleshooting section of this User’s Manual.

D-Sub Connector

DVI Connector