User guide

English
English-5
Quick Start - Continued
Tilt and swivel
Grasp both sides of the display screen with your hands and adjust the tilt and swivel as desired (Figure E).
Remove Display Stand for Mounting
To prepare the monitor for alternate mounting purposes:
1. Disconnect all cables.
2. Place hands on each side of the monitor and lift up to the highest position.
3. Place monitor face down on a non-abrasive surface (Place the screen on a 55 mm/2.2 inch platform so that the stand is
parallel with the surface) (Figure F).
4. Remove the 4 screws connecting the display to the stand and lift off the stand assembly (Figure G).
The display is now ready for mounting in an alternate manner.
5. Connect the AC cord and signal cable to the back of the display (Figure H).
6. Reverse this process to reattach stand.
Note: Use only VESA-compatible alternative mounting method. (100mm pitch)
Note: Handle with care when removing display stand.
Caution:
Please use the attached screws (4pcs) as shown in the picture when installing.
To meet the safety requirements, the display must be mounted to an arm which guaranties the necessary stability under consid-
eration of the weight of the display.
The LCD display shall only be used with an approved arm (e.g. GS mark).
Figure F
55 mm
Figure G
Figure H
Figure E
Note: Handle with care when tilting the monitor screen.