User`s guide

76 007-3938-003
3: L1 and L2 Controller Commands
• Use pbay reset to reset the power bay and the power supplies.
• Use pbay env to view the status of environmental monitoring.
• Use pbay env on|off to enable or disable environmental monitoring.
• Use pbay init to initialize communication with the power bay.
• Use pbay serial to display the power bay ICMB card serial number.
Used on C-bricks, I/O-bricks, R-bricks, and graphic bricks.
pci
The following pci command set displays the status of the PCI cards in an I/O brick, an
Origin 300 server, or a PCI expansion module, and powers up, powers down, and resets
a PCI card.
• pci
• pci <u|d>
• pci <bus> u|d
• pci <bus> <slot> u|d
• pci reset
• pci <bus> reset
• pci <bus> <slot> reset
Note: For this command set, the mnemonic rst may replace the word reset.
Use the pci command to view the value of the status register for each PCI card. The
output of the pci command contains eight columns, as follows:
• The Bus column lists the number of the bus for each PCI card.
• The Slot column lists the slot value for each PCI card.
• The Stat column lists the hexadecimal value of the status register for each PCI card.
• The Card Type column lists the card type (7.5 W, 15 W, 25 W, or none) for each slot.