User`s guide

74 007-3938-003
3: L1 and L2 Controller Commands
nvram reset
The nvram reset command returns the NVRAM settings of the L1 controller to the
factory default settings.
Used on all bricks.
partdb
The following partdb command set displays, enables, and disables partitioning.
• <partdb>
• <partdb enable>
• <partdb disable>
Note: For this command set, you can use e or on instead of enable and d or off instead
of disable.
Use partdb to display partition information from the database. Use partdb enable
to enable the partition for a system, and use partdb disable to disable the partition
for a system.
Used on C-brick or on server bricks performing the compute function and I/O bricks.
Note that this command is valid only for the C-brick if a C-brick is present.
pbay
The following pbay command set displays information about the power bay, distributed
power supplies (DPSs), DC output ports, and field replaceable units (FRUs):
• pbay
• pbay version
• pbay dps
• pbay dps <dps number 1 - 6>
• pbay dcport