User`s guide

L1 Controller Commands
007-3938-003 71
• margin|mgn 2.5xio default|low|norm|high
Set Fuel XIO voltage
Used on all bricks.
network
The following network command set displays and sets the mode of the network
communication interface. (For systems that include a C-brick, this command is valid only
for C-bricks.)
• network
• network usb
• network 422
• network autodetect|auto on
• network autodetect|auto off
Use network to view the current mode of the network communication interface.
Example 3-41 shows sample output.
Example 3-41 network Command Output
001c07-L1>network
network interface communication is USB
Use network usb to set the network communication interface mode to Universal Serial
Bus (USB) and disable autodetection. Use network 422 to set the network
communication interface mode to RS-422 protocol and disable autodetection.
Example 3-42 shows sample output from the network usb command.
Example 3-42 network usb Command Output
001c003-L1>network usb
nvram parameter changed, reset required to affect change.
Use network autodetect|auto on to turn on the autodetection. Use network
autodetect|auto off to turn off the autodetection.