User`s guide

66 007-3938-003
3: L1 and L2 Controller Commands
Used on C-bricks or server bricks performing the compute function. Note that, if a
C-brick is present, this command is only valid on the C-brick.
link
Use the link command to show the error status for the network interface (NI) and I/O
interface (II) connector links.
Use the link verbose command to show the complete status for the NI and II
connector links.
Note: For this command, you can use v in the place of verbose.
Used on all bricks.
log
The following log command set displays the contents of the log, clears or resets the log,
and writes an entry into the log.
• log
• log clear|reset
• log insert <entry>
Use log to view the contents of the log. Example 3-38 shows sample output. If the log is
empty, the output from the log command is “log is empty.”
Example 3-38 log Command Output
001c07-L1>log
USB: registered as remote
USB-R: USB:device was reset
USB: unregistered
USB-R: IRouter:read failed - read error
USB: registered as remote
USB-R: USB:device was reset
USB: unregistered
USB-R: IRouter:read failed - read error