User`s guide

L1 Controller Commands
007-3938-003 51
DIMM 6 - no hardware detected
DIMM 1 (SPD)
80 08 07 0c 0a 02 48 00 04 a0 80 02 80 08 08 01
0e 04 04 01 02 26 00 00 00 00 00 50 3c 50 30 40
b0 b0 60 60 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 51
ce 00 00 00 00 00 00 00 01 4b 4d 4d 33 20 34 36
4c 33 33 31 33 42 20 54 2d 47 30 20 42 05 00 14
19 02 09 ff ff ff ff ff ff ff ff ff ff ff ff ff
ff ff ff ff ff ff ff ff ff ff ff ff ff ff 64 ff
DIMM 3 - no hardware detected
DIMM 5 - no hardware detected
DIMM 7 - no hardware detected
Used on all bricks.
env
The following env command set provides the status of environmental conditions and
turns environmental monitoring on and off.
• env
• env check
• env on|off
• env temp on|off
• env altitude high|low
• env reset
• env test warning
• env test fault
• env test tmpady
• env test tmpcrit
Note: For this set of commands, you can use rst in place of reset.