User`s guide

46 007-3938-003
3: L1 and L2 Controller Commands
Use the cpu command to view the status of all cpus. Example 3-11 shows a sample
output from the cpu command on a C-brick:
Example 3-11 cpu Command Output
T1-038c01-L1>cpu
CPU Present Enabled
--- ------- -------
01 1
11 1
21 1
31 1
Use the other commands in this set as follows:
• Use cpu e to enable all cpus, and use the cpu d command to disable all cpus.
• Use cpu <exp> e to enable the number of the cpu entered.
• Use cpu <exp> d to disable the number of the cpu entered.
Used on a C-brick or on server bricks performing the compute function.
ctc
Use ctc <command> to send a command to a network interface (NI) port (port A). The
NI port is found on devices such as a C-brick. Example 3-12 shows sample output from
the ctc version command.
Example 3-12 ctc version Command Output
003c01-L1>ctc version
002c01:
L1 0.7.37 (Image A), Built 05/24/2000 14:59:42 [P1 support]