User`s guide

40 007-3938-003

3: L1 and L2 Controller Commands

• If no target is speciﬁed and <command> is an L2 controller command, it is executed

on the local L2 controller only. If the L2 controller does not understand the

command, it passes it on to all the L1 controllers in the default destination. (The

destination command shows the default destinations.)

• If the target is speciﬁed and <command> is an L2 controller command, it is executed

on the targeted L2 controllers. If the command is not understood by the L2

controller, it passes on the command to all L1 controllers on the target list.

• For overlapping L2 controller commands and L1 controller commands, precede the

<command> with L1 to override the L2 interpretation.

L1 Controller Commands

The following subsections describe the L1 controller commands and command sets,

which are listed alphabetically. Examples of output are included where applicable.

For a list of all L1 controller commands, enter the following:

T1-001c01-L1>help

Commands are:

* autopower|apwr junkbus|jb|bedrock brick

partdb cpu nia|ni|ctc nib

iia|ii|cti iib iic iid

config|cfg debug display|dsp env

fan help|hlp history|hist l1dbg

link log ioport|ioprt istat

l1 leds margin|mgn network

pimm port|prt power|pwr reset|rst

nmi softreset|softrst select|sel serial

eeprom uart usb verbose

router|rtr date nvram security

fuel flash reboot_l1 version|ver

pbay test|tst scan pci

For more information on a single command, enter the following:

T1-001c01-L1>hlp <command>