User`s guide

007-3938-003 37
Chapter 3
3. L1 and L2 Controller Commands
You can use L1 and L2 controller commands to monitor and manage the SGI Origin 3000
series servers, SGI Origin 300 servers, SGI Origin 300 servers with a NUMAlink module,
SGI Altix 350 systems, SGI Altix 3000 family of servers and superclusters, SGI Onyx 3000
graphics systems, and SGI Onyx 300 graphics systems. This chapter consists of the
following sections:
• “Commands for Different Devices” on page 37
• “Sending Commands to Specific Devices” on page 39
• “L1 Controller Commands” on page 40
• “L2 Controller Commands” on page 93
Note: Online command information is available. To view a list of L1 commands, enter
help at the L1 prompt. To view a list of L2 commands, enter help at the L2 prompt. To
view information about an individual command, enter help and the command name at
the appropriate prompt.
Commands for Different Devices
This section explains which L1 and L2 controller commands can be used with which
devices in the following sections:
• “L2 Commands” on page 38
• “L1 Commands” on page 38