User`s guide

Status and Error Messages
007-3938-003 31
To set the rack and slot from the L1 prompt, simply use the brick rack and brick
slot commands. To set the rack and slot on one of the attached bricks (an attached I/O
brick, C-brick, or a C-brick’s I/O brick), use the L1 targeting commands iia, iib, or
nia, nib. See the following example.
003c01-L1> config verbose
:0 - 003c01 (local)
:1 - ---i-- (IIA)
:5 - 002c01 (NIA)
:6 - 001x01 (IIA NIA)
003c01-L1> iia brick rack 4
---i--:
brick rack set to 004.
003c01-l1> iia reboot_l1
003c01 ERROR: no response from ---i--
003c01-L1> config
:0 - 003c01 (local
:1 - 004i01 (IIA)
:5 - 002c01 (NIA)
:6 - 001x01 (IIA NIA)
003c01-L1>
Status and Error Messages
This section lists and describes the status and error messages generated by the L1 and L2
controllers. It also explains how to resolve the errors, if action is necessary.
L1 Controller Tasks and Messages
The L1 controller front panel display, located on the front panel of individual bricks,
consists of a 2-line, 12-character liquid crystal display (LCD) that provides the following:
• Brick identification
• System status
• Warning of required service or failure
• Identification of failed components