User`s guide

24 007-3938-003
2: Using the L1 and L2 Controllers
Console Selection
The brick with which the L1 communicates in console mode is the system console or
global master, and you can view and set it with the select command. By default, the
C-brick attempts to communicate with its local CPUs when it enters console mode. If the
system has been powered on and either one of the bricks has a request to be the system
console, then the C-brick attempts to communicate with that brick. Enter the select
command alone to show the current console mode settings, as follows:
003c01-L1> select
console input: 003c01 console
console output: not filtered.