User`s guide

112 007-3938-003
3: L1 and L2 Controller Commands
Example 3-89 select subchannel <a|b|c|d> Command Output
L2>select subchannel c
console input: 003c01 CPUc
console output: not filtered
console detection: L2 detected
Use select <rack>.<slot> to select the brick (brick ID) that receives console input. The
variable <rack> is a rack number and the variable <slot> is a slot number. In
Example 3-90, the brick ID is a C-brick in rack 3, slot 1 (003c01).
Example 3-90 select <rack>.<slot> Command Output
L2>select 3.1
console input: 003c01 console
console output: not filtered
console detection: L2 detected
Alternatively, use select <exp> <exp> to enter the rack and slot of the brick that
receives the console input.
Use select reset to reset the selection of the brick to receive the console input to the
default setting. Use select partition <exp> to select the partition and system
console to receive the console input.
Use select filter on to turn the console output filter on, and select filter off
to turn the console output filter off. Example 3-91 shows sample output.
Example 3-91 select filter on Command Output
L2>select filter on
console input: 003c01 console
console output: filtered
console detection: L2 detected