User`s guide

L2 Controller Commands
007-3938-003 111
• select partition <exp>
• select filter on
• select filter off
Note: For this command set, the mnemonic sel, t, sub (or s), con, part (or p), res
may replace the words select, terse, subchannel, console, partition, and
reset.
Use the select command to view the brick ID number and subchannel that receives
console input. Example 3-88 shows sample output. In this example, the brick ID is a
C-brick in rack 2, slot 1 (002c01) and the subchannel is the console channel.
Example 3-88 select Command Output
L2>select
console input: 002c01 console
console output: not filtered
console detection: L2 detected
Alternatively, you can use select terse to provide a less detailed display of
information identifying the brick ID number and the subchannel that receives the
console input.
Use select subchannel console to select the current console as the subchannel of
the brick that receives the console input. Use select subchannel <a|b|c|d> to
select CPU a, b, c, or d of the brick that receives the console input. Alternatively, use
select subchannel <exp> to select the subchannel CPU of the brick that receives that
console input. In this command, the variable <a|b|c|d> is the subchannel letter (a, b, c,
or d CPU) of the brick to receive the console input. Example 3-89 shows sample output.