User`s guide

110 007-3938-003
3: L1 and L2 Controller Commands
Note: For the reset command set, you can use rst in the place reset, r in the place of
rack, and s in the place of slot.
Use reset to reset the individual default brick or bricks.
Caution: If you enter a reset command at the L2 prompt, it will reset all the bricks in
your server system, which can create problems for your operating system if the operating
system is running when you enter the reset command. So make sure your operating
system is shut down before using the reset command.
Use rack <rng> slot <rng> reset to reset the bricks specified by the rack number(s)
and slot number(s) specified with the variable <rng>.
Note: For the <rng> variable, you can enter a single number, or two numbers separated
by a hyphen to indicate a range, or numbers separated by commas to indicate separate
items. For <rng>, you can also enter an asterisk or the word “all” to select all the items
available.
select
The following select command set displays and sets the brick ID number of the compute
brick and subchannel that receives console input.
• select
• select terse
• select subchannel console
• select subchannel <a|b|c|d>
• select subchannel <exp>
• select <exp> <exp>
• select <rack>.<slot>
• select reset