User`s guide

L2 Controller Commands
007-3938-003 107
• Use ping sender <1 or 0> to enable (1) or disable (0) sender ping as a valid
response.
• Use ping l1<frequency in seconds> to set L2 controller to L1 controller ping
frequency in seconds.
• Use ping reset to reset L2 controller to L2 controller and L2 controller to L1
controller ping configuration to default.
power
The following power command set displays the power status of the bricks and powers
up and powers down the bricks.
• power
• power up
• power down
• rack <rng> slot <rng> power
• rack <rng> slot <rng> power up
• rack <rng> slot <rng> power down
• power summary
• rack <rng> slot <rng> power summary
• power delay
• power delay <milliseconds>
Note: For the power command set, the mnemonics pwr, u, d, and s may replace the
words power, up, down, and summary. The mnemonics r and s may replace the words
rack and slot.
Use the power command to view the power status of each brick identified by the
destination set of commands. Use the power up and power down commands to power
up or power down each brick identified by the destination set of commands.
Example 3-84 shows sample output.