User`s guide

106 007-3938-003

3: L1 and L2 Controller Commands

nvram reset

The nvram reset command returns the NVRAM settings of the L2 controller to the

factory default settings.

pbay

Use pbay config to report the bricks connected to each power bay. Use pbay

<command> to send a speciﬁed command to one L1 controller connected to each power

bay.

ping

Use the following ping command set to set the ping function between L2 controller and

L2 controllers or L2 controller and L1 controllers.

• ping

• ping min <frequency in seconds>

• ping max <frequency in seconds>

• ping l2 <frequency in seconds>

• ping sender <1 or 0>

• ping l1 <frequency in seconds>

• ping reset

Use the commands in this set as follows:

• Use ping to display the L2 controller to L2 controller or L2 controller to L1

controller ping conﬁgurations.

• Use ping min <frequency in seconds> to set the L2 controller to L2 controller ping

response to a minimum speciﬁed in <frequency in seconds>.

• Use ping max <frequency in seconds> to set the L2 controller to L2 controller ping

response to a maximum speciﬁed in <frequency in seconds>.

• Use ping l2 <frequency in seconds> to set the L2 controller to L2 controller ping

frequency.