User`s guide

L2 Controller Commands
007-3938-003 105
Use log clear|reset to empty the log. Use log insert <entry> to write a line in
the log. The variable <entry> is text to enter in the log. Example 3-82 shows sample
output where the text for <entry> is “Start the Test.”
Example 3-82 log insert Start the Test Command Output
L2>log insert Start the Test
log entry made.
multisys
Use the following multisys command set to enable, disable, and show the settings for
multiple system network sharing.
• multisys
• multisys on
• multisys off
Note: For these commands, msys can replace the word multisys.
Use the multisys command to view the current setting for the L2 controller multiple
system network sharing. Example 3-83 shows sample output.
Example 3-83 multisys Command Output
L2>multisys
L2 multiple system network support enabled.
L2’s will only connect to L2s with same system SN.
L2>
Use multisys on to enable multiple L2 controller system network sharing. Network
sharing enables L2s to communicate only with other L2s that have the same serial
number. Use multisys off to disable multiple L2 controller system network sharing.
When L2 controller system network sharing is disabled, L2s communicate with all L2s.