User`s guide

104 007-3938-003
3: L1 and L2 Controller Commands
l2display
Use the following l2display command set to set the functioning of your L2 controller
touch display.
• l2display debug <exp>
• l2display debug
• l2display enable
• l2display disable
• l2display
Note: For these commands, l2dsp can replace l2display in your entries.
Use the commands in this set as follows:
• Use l2display debug <exp> to set the L2 controller touch display to display the
debug flags specified in <exp>.
• Use l2display debug to show the L2 controller touch display debug flags.
• Use l2display enable to enable the L2 controller touch display.
• Use l2display disable to disable and lock the L2 controller touch display.
• Use l2display to show whether the L2 controller touch display is locked.
log
The following log command set displays the contents of the log, resets the log, and
writes an entry into the log.
• log
• log clear|reset
• log insert <entry>
Use the log command to view the contents of the log. If the log is empty, the output from
the log command is log is empty.