User`s guide

L2 Controller Commands

007-3938-003 103

Use rack <rng> slot <rng>l2to engage a speciﬁed L2 controller. The <rng> variable

speciﬁes the rack number(s) and slot number(s).

Note: For the <rng> variable, you can enter a single number, or two numbers separated

by a hyphen to indicate a range, or numbers separated by commas to indicate separate

items. For <rng>, you can also enter an asterisk or the word “all” to select all the items

available.

Use rack <rng> slot <rng> l2 <command> to send a speciﬁed command to a

speciﬁed L2 controller(s). Use <ip> l2 <command> to send a speciﬁed command to an

L2 controller speciﬁed with its IP address.

l2ﬁnd

The l2find command lists all of the L2 controllers that are connected together on the

same subnet (see Example 3-81).

Example 3-81 l2find Command Output

L2>l2find

13 L2's discovered:

IP SSN NAME RACK FIRMWARE

--------------- -------- ---------------- ---- ------------

[ L2's with System Serial Number NOT set ]

137.38.82.101 000 L3 controlle

137.38.82.102 000 L3 controlle

[ L2's with different System Serial Numbers ]

137.38.82.156 L1000625 001 1.8.0

137.38.82.51 N1000405 itsys1 111 1.7.7

137.38.82.58 L0000002 klsys2 002 1.7.7

137.38.82.159 L0000138 klsys4 004 1.7.9

137.38.82.162 L0000005 klsys5 005 1.7.7

137.38.82.57 L0000007 klsys7 007 1.8.0

137.38.82.55 L0000123 perch 009 1.7.7

137.38.82.158 L0000018 shrimp 018 1.7.7

137.38.82.50 N0000001 sn2-dbg2 022 1.7.7

137.38.82.52 M0000114 snapper 015 1.7.7

137.38.82.157 L0000119 whale 008 1.7.7