User`s guide

100 007-3938-003

3: L1 and L2 Controller Commands

Use the ip command to display the L2 controller static IP address settings. Example 3-77

shows sample output.

Example 3-77 ip Command Output

essc1-001-L2>ip

addr: 137.38.88.197 netmask: 255.255.255.0 broadcast addr: 137.38.88.255

essc1-001-L2>

Use the other commands in this set as follows:

• Use ip <addr><netmask> to set the address and netmask L2 static IP conﬁguration

parameters.

• Use ip <addr> <netmask> <broadcast> to set the address, netmask, and broadcast

L2 static IP conﬁguration parameters.

• Use ip clear|reset to clear the L2 static IP address settings.

The following l1 command set enters L1 mode or sends an L1 controller command to a

speciﬁed L1 controller.

• l1

• rack <rng> slot <rng> l1

• <rack>.<slot> l1

• rack <rng> slot <rng> l1 <command>

• <rack>.<slot> l1 <command>

• <ip>:<port>:<l1> l1 <command>

• :<port>:<l1> l1 <command>

• l1 <command>

Note: For these commands, the mnemonics r and s may replace the words rack and

slot.

Use l1 to engage the default

L1 command processor

or enter the l1 mode.