User`s guide

L2 Controller Commands

007-3938-003 99

Use env summary to generate an environmental summary of an entire system.

Example 3-76 shows sample output.

Example 3-76 env summary Command Output

L2>env summary

all environmental conditions appear normal

L2>

Use rack <rng> slot <rng> env summary to display an environmental summary

for speciﬁed rack number(s) and slot number(s).

Note: For the <rng> variable, you can enter a single number, or two numbers separated

by a hyphen to indicate a range, or numbers separated by commas to indicate separate

items. For <rng>, you can also enter an asterisk or the word “all” to select all the items

available.

help

Use the help command to generate a list of all of the system controller commands. Use

the help <command> command to display more information on a single command. The

variable <command> is the name of a command.

Note: For this command, hlp may replace the word help.

For information about entering commands, see “Sending Commands to Speciﬁc

Devices” on page 39.

Use the following ip command set to set, clear, and show the L2 controller static IP

address conﬁguration settings.

• ip

• ip <addr> <netmask>

• ip <addr> <netmask> <broadcast>

• ip clear|reset