User`s guide

98 007-3938-003
3: L1 and L2 Controller Commands
Use destination reset to reset the destination of L2 commands to all bricks in all
racks and all slots. Example 3-74 shows sample output.
Note: For this command, the mnemonic rst may replace the word reset.
Example 3-74 destination reset Command Output
L2>destination reset
default destination reset to all bricks and slots
dhcpserver
The following dhcpserver command set displays the setting for the current DHCP server
(see Example 3-75) and enables and disables the DHCP server.
• dhcpserver
• dhcpserver on|enable
• dhcpserver off|disable
Note: For this command, the mnemonic dhcps may replace the word dhcpserver.
Example 3-75 dhcpserver Command Output
L2>dhcpserver
DHCP server startup enabled (if no other DHCP server is found).
env
The following env command set provides an environmental status summary.
• env summary
• rack <rng> slot <rng> env summary
Note: For this command, r may replace the word rack; s may replace the word slot
and may also replace the word summary.