User`s guide

L2 Controller Commands

007-3938-003 97

destination

The following destination command set displays the brick identiﬁcation numbers of

bricks that are the destinations of L2 commands, and sets the bricks that are the

destinations for L2 commands.

• destination

• rack <rng> slot <rng> destination

• destination reset

Note: For these commands, the mnemonic dest may replace the word destination.

Also, the mnemonics r and s may replace the words rack and slot.

Use the destination command to view the brick identiﬁcation numbers of the bricks

that are the destinations of L2 commands. Example 3-72 shows sample output.

Example 3-72 destination Command Output

L2>destination

all racks, all slots

Use rack <rng> slot <rng> destination to set individual bricks that are the

destinations for L2 commands. The variable <rng> speciﬁes a rack number(s) and slot

number(s).

Note: For the <rng> variable, you can enter a single number, or two numbers separated

by a hyphen to indicate a range, or numbers separated by commas to indicate separate

items. For <rng>, you can also enter an asterisk or the word “all” to select all the items

available.

Example 3-73 rack <rng> slot <rng> destination Command Output

L2>r 1 s 7 destination

1 default destination(s) set

L2> destination

001c07 (127.0.0.1:1:0)