User`s guide

94 007-3938-003
3: L1 and L2 Controller Commands
Use the autopower command to view the current auto power-up setting. Example 3-69
shows the sample output.
Example 3-69 autopower Command Output
L2>autopower
auto power up appears disabled
L2>
Use autopower on to enable the auto power on. Use autopower off to disable the
auto power on. Use autopower abort to abort the auto power on.
config
The following config command set displays configuration information.
• config
• config summary
• config verbose
• config l2
• config l2 verbose
• config rescan
• config auto
• config manual
• config print
• config print all
Note: For these commands, the mnemonic cfg may replace the word config, and s, v,
and re may replace the words summary, verbose, and rescan.
Use the config command to view configuration information for all the L1 controllers
connected to all the L2 controllers in the server system (see Example 3-70). In the config
command output, the first number is the IP address of the L2 controller (127.0.0.1 in the
output below). The number that follows the IP address, after the first colon, is the USB
port number (1 in the output below).