Manualshelf

User`s guide

ManualsBrandsSGI ManualsComputer equipmentOrigin 3900
111112113114115116117118119120
L2 Controller Commands
007-3938-003 93
verbose
Use the verbose command to get a system maintenance port (SMP) prompt and get into
character-echo mode.
Used on all bricks.
version
Use the version command to view the version of the firmware that is currently running
in the system controller. Example 3-68 shows sample output.
Example 3-68 version Command Output
001r19-L1>version
L1 0.7.27 (Image A), Built 04/28/2002 13:06:43 [P1 support]
Used on all bricks.
L2 Controller Commands
The following subsections describe the L2 controller commands and command sets,
which are listed alphabetically. Examples of output are included where applicable.
autopower
The following autopower command set enables, disables, aborts, and shows the current
auto power status.
• autopower
• autopower on
• autopower off
• autopower abort
Note: For these commands, the mnemonic apwr may replace the word autopower.