User`s guide

L1 Controller Commands
007-3938-003 89
• Use serial dimm to show the dual-inline memory module (DIMM) part and serial
number.
• Use serial clear to clear the SSN.
• Use serial <str> <str> <str> <str> to erase and reassign the device’s SSN. The
variable <str><str><str><str> is the value of a security key that is provided only
to SGI employees.
• Use serial security on to enable the SSN security.
Used on all bricks.
softreset
Use the softreset command to issue a software reset. In systems that include a
C-brick, the softreset command is valid only for the C-brick.
After receiving a softreset command, the system controller displays “Sft rst...” on the
front panel display and asserts the soft reset signal in I/O expander B_0100001x. If no
errors occur while the system controller issues the soft reset, it displays “Sft rst done” on
the front panel display (see Example 3-64 and Figure 3-2). If an error occurs while the
system controller issues the soft reset, it displays “Sft rst fail” on the front panel display.
Note: For this command, you can use the mnemonic softrst instead of the word
softreset.
Example 3-64 softreset Command Output
001c07-L1>softreset
001c07-L1>