User`s guide

84 007-3938-003

3: L1 and L2 Controller Commands

Note: For the router command set, you can use rtr instead of router, rep instead of

repeater, and ord instead of ordinary.

Use router to view the current router type. Example 3-62 shows sample output.

Example 3-62 router Command Output

001r19-L1>router

router type is ordinary

Use the other commands in this set as follows:

• Use router meta to set the router type to meta.

• Use router repeater to set the router type to repeater.

• Use router ordinary to set the router type to ordinary.

• Use router 6 port to enable all 6-port router ports.

• Use router 8 port to enable all 8-port router ports.

• Use router 8 port <str><str><str><str> to enable all the 8-port router ports of

the router speciﬁed with the IP address listed for the <str> <str> <str> <str>

variable.

• Use router service <str> <str> <str> <str> to set into service mode, for repair,

the 8-port router speciﬁed with the IP address listed for the <str> <str> <str> <str>

variable.

• Use router service off to disable the service mode after the repairs are

completed.

• Use router spare to conﬁgure the router for spare tear down.

Used on R-bricks and NUMAlink modules.

scan

Use the scan command to perform a JTAG boundary scan hard reset or soft reset.

• scan reset

Perform hard and soft JTAG reset